about us
News Center
Your current location:Home - About us - News center
An RJ45 splitter and a USB hub both look like ways to turn one port into three, which is why the comparison keeps coming up. They behave nothing alike. Ethernet, in the office and on the factory floor, is a point-to-point star: each device owns its link to a switch, and a passive RJ45 splitter usually just lands two devices on the same pairs so that neither works properly at the same time. A USB hub is an active, host-driven device that negotiates with each downstream port. Neither model describes a CAN branch, and treating the two as interchangeable is the fastest way to specify the wrong part. A three-way M12 distributor contains no electronics at all. It is a passive junction sitting on a shared bus, which is why it can be a molded housing with contacts, seals and threads rather than a powered box. There is nothing to enumerate, no addressing to assign and no power budget to allocate; the bus protocol already handles who talks and when. That passivity is a feature in a control cabinet, because a junction with no active components has nothing to reset, nothing to firmware-update and nothing to fail quietly in a hot machine frame. The differences also show up in the interfaces. M12 threads lock the joint and compress the seal, the IP67 rating covers dust and short-term water exposure, keyed coding stops a D-coded plug from being forced into an A-coded socket, and the -40°C to +85°C range covers both a cold outdoor gantry and a warm cabinet interior. Parts like this typically come from hybrid connector manufacturers that also build cable assemblies and molded housings, so the same family often spans 4-pin, 5-pin and 8-pin variants. Buyers comparing hybrid connector suppliers tend to settle pin count, coding and sealing first, because those three decide whether the branch will physically fit the machine.